c. Cleaning and Inspection.
e. Installation.
(1) Clean all parts.
(1) Install mounting hardware.
(2) Inspect all parts for defects.
(2) Connect hydraulic lines.
(3) Replace seals and defective parts.
d. Reassembly. Refer to figure 3-13
3-17. Hydraulic Reservoir
reassemble cushion valve.
e. Installation
a. Removal.
(1) Install mounting hardware.
(1) Remove engine (para 2-8).
(2) Connect hydraulic lines.
(2) Drain hydraulic reservoir.
(3) Disconnect hydraulic lines from hydraulic
3-16. Pressure Regulator
reservoir.
(4) Remove hydraulic reservoir.
a. Removal. Disconnect hydraulic lines and
b. Cleaning and Inspection.
mounting hardware from pressure regulator.
(1) Clean reservoir.
b. Disassembly. Refer to figure 3-13 to disassemble
(2) Inspect for defects. Repair or replace
pressure regulator.
hydraulic tank as necessary.
c. Cleaning and Inspection.
c. Installation.
(1) Clean all parts.
(1) Install hydraulic reservoir.
(2) Inspect all parts for obvious defects.
(2) Install hydraulic lines.
(3) Replace defective parts as necessary.
(3) Install engine (para 2-8).
d. Reassembly. Refer to figure 3-13 reassemble
(4) Fill hydraulic tank (LO 5-3950-203-12).
pressure regulator.
Section VII. STEERING SYSTEM
3-18. Steering Cylinder
b. Disassembly. Disassemble steering cylinder as
a. Removal. Remove steering cylinder (TM 10-
shown in figure 3-14, starting with cylinder base
3950-203-20).
end (11), to extent necessary to repair the cylinder.
Figure 3-14. Steering cylinder, exploded view.
3-24
