TM 10-3950-206-12
Figure 4-41. Valve adjustment.
Section XIII. TRANSMISSION MAINTENANCE
linkage moves shift lever position to the rear.
4-56. General
e. Install yoke (12) on pivot lever (16) with pin (13)
The transmission is mounted between the engine and
and cotter pin (33). Tighten nut (14) against yoke (12) to
drive axle assembly, immediately below operator's
lock adjustment.
compartment floor plates.
The transmission is
f. Using direction shift lever (30) shift transmission
connected to the torque' converter on one end and to the
into forward and reverse. Watch linkage, shift lever, and
differential pinion gear on the other. It is a constant-
transmission range selector during shifting to be sure
mesh, full reversing, power-shifted type. The forward
there is no obstruction and transmission goes completely
and reverse directions are selected by positioning
into all gears.
direction shift lever mounted on right side of operator's
seat. The direction shift lever is connected by
4-58. Transmission Oil Piping
mechanical linkage to selector lever on side of
a.
Refer to figure 4-43, and remove the
transmission. A neutral start switch is provided as a
transmission oil piping as required.
safety feature.
b. Replace any parts which are damaged in any
4-57. Lever and Linkage Adjustment
way
If direction shift lever is in neutral position and too far
4-59. Transmission Oil Filter
forward or too far to the rear for convenient operation,
a. Removal.
adjust shift lever linkage as follows:
(1) Disconnect oil hose assemblies from filter
a. Move direction shift lever (30, fig. 4-42) to
head (fig. 4-1).
neutral position in shift gate (2). Remove cotter pin (33)
(2) Remove two capscrews and lockwashers
and pin (13) that secure yoke (, 12) to pivot lever (16).
that secure oil filter to frame. Remove filter assembly.
b. Move pivot lever (16) until transmission range
b. Disassembly.
selector is in neutral position. Note. At this point neutral
(1) Loosen bolt (11, fig. 4-44) and separate
start switch (36) should be depressed by pin (34).
head (5) from body (9).
c. Loosen nut (14) that locks yoke (12) on rod (15).
(2) Remove and discard seal (6) and element
d. Adjust yoke (12) so that direction shift lever (30)
(7).
will be in neutral position of shift gate (2) when yoke is
(3) Remove spring (8) from detent in bolt (11)
connected to pivot lever (16). Shortening the linkage
and remove bolt and washer (10) from body (9).
moves shift lever position forward. Lengthening the
4-45
