Hydraulic tank........................... 2 qt
(4) Heaters.
Power transfer reduction
(a) Battery heater.
gear case .............................. 8 qt
Manufacturer ............................ Perfection Industries Division
Horizontal vertical drive
of Hupp Corp.
gear case .............................. 12 qt
Model ....................................... MH15-B2
Heater fuel tank ........................ 18 gal
Volts ......................................... 24 VDC (volts direct current)
(6) Starter.
Control type .............................. Remote
(a) For model 687C-18-ES.
Temperature selection............... Manual
Manufacturer ............................ Delco Remy
Fuel .......................................... Gasoline
Model ....................................... 1113757
Consumption rate
Volts ......................................... 24 VDC
High heat ........................... 0.25 gph (gallons per hour)
Rotation.................................... Counterclockwise at drive end
Heat output
New brush spring tension.......... 24 to 28 oz (ounce (s))
High heat ........................... 15,000 BTU (British Thermal
Units)
(b) For model D333TA.
(b) Personnel heater.
Manufacturer ............................ Delco Remy
Model ....................................... 1113771 or 1113818
Manufacturer ............................ Perfection Industries Division
Volts ......................................... 24 VDC
of Hupp Corp.
Rotation at drive end................. Clockwise
Model ....................................... E-510
No load test:
Volts ......................................... 24 VDC
Volts ..................................... 23.0
Control type ............................. Remote
Maximum amps
Temperature selection .............. Manual
(amperes) .......................... 82.5 for 1113771 and 90 for
Fuel ......................................... Gasoline
1113818
Consumption rate
Minimum rpm ........................ 7,000
Low heat ........................... 0.6 gph
Lock test:
High heat .......................... 0.75 gph
Volts .................................... 3.5
Heat output
Maximum amps..................... 500
High heat .......................... 60,000 BTU
Minimum torque .................... 26 ft-lb (foot-pounds)
Low heat ........................... 30,000 BTU
Minimum brush spring
(c) Engine heater.
tension .................................. 80 oz
Manufacturer ............................ Perfection Industries Division
(7) Generator (model 687C-18-ES).
of Hupp Corp.
Manufacturer ............................ Delco Remy
Model ....................................... E-511
Model ....................................... 1117478
Volts ......................................... 24 VDC
Volts ......................................... 24 VDC
Control type .............................. Remote
Ground polarity control ............. Current-voltage regulator
Temperature selection............... Manual
Rated output ............................. 40 amps (amperes)
Fuel .......................................... Gasoline
New brush spring tension.......... 28 oz
Consumption rate
Rotation.................................... Clockwise
Low heat ............................ 0.5 gph
High heat ........................... 0.75 gph
(8) Alternator (model D33STA).
Heat output
Manufacturer ............................ Delco Remy
High heat ........................... 60,000 BTU
Model ....................................... 1117072
Low heat ............................ 30,000 BTU
Brush spring tension ................. 10 oz
(5) Capacities.
Rotation (viewing drive
end) ...................................... Clockwise
(a) Engine, model 687C-18-ES.
Circuit....................................... A or B (normally B)
Crankcase ............................... 32 qt (quart)
Field Current (80 F):
Fuel filters:
Volts ..................................... 24 VDC
Primary ................................. pt (pint)
Amps .................................... 3.6 to 4.0
Secondary ............................. 1 pt
Output (cold):
Cooling system ......................... 36 qt
Volts ..................................... 28 VDC
Air cleaner ................................ 4 qt
Amps .................................... 61 amps
Oil filters ................................... 2 qt
Approximate RPM..................... 2,500
Transmission case .................... 8 qt
(9) Generator regulator (model 687C-18-ES).
(b) Engine, model D3SBTA.
Manufacturer ............................ Delco Remy
Crankcase ................................ 22 qt
Model ....................................... 1118658
Cooling system ......................... 33.6 qt
Type ......................................... M11ST48803
Transmission case .................... 8 qt
Volts ......................................... 24 VDC
(c) Crane capacities.
Circuit....................................... B
Fuel tank................................... 90 gal (gallons)
Amperes ................................... 40
Swing gear box (oil) .................. 20 qt
Ground ..................................... Negative
Chain case................................ 8 qt
12 Hydraulic cylinders ............... 4 qt
7 Hydraulic cylinders................. 2 qt
1-6
