Figure 3-132. Panels and swinging door, removal and installation.
(2) Visually inspect bearings for excessive
wear, door for bends, cracks, or other damage.
(1) Unhook latch.
(3) Repair by straightening bends, welding
(2) Refer to figure 3-132, remove nine nuts,
cracks, or replacing defective bearings or door.
washers and screws, then remove swinging door.
(3) Install in reverse order.
b. Cleaning, Inspection, and Repair.
3-169. Doors on Winterized Models
(1) Clean all parts in an approved cleaning
Doors on winterized models (fig. 3-133 and 3-134) are
solvent and dry thoroughly.
removed and installed in manner similar to that
(2) Visually inspect door for defective hinges,
described in paragraph 3-167.
dents, cracks, or other defect.
(3) Repair by straightening bends, welding
3-170. Left Hand Center Side Panel
cracks, or replacing defective hinge or door.
a. Removal and Installation.
(1) Refer to figure 3-132 and remove center
3-168. Sliding Doors
panel from left side.
a. Removal and Installation.
(2) Install in reverse order.
(1) Refer to figure 3-133 and unhook latch.
b. Cleaning, Inspection, and Repair.
Clean,
(2) Remove two roller bearings and washers
inspect, and repair panels in manner similar to that
from pins then lift right rear sliding door from guides.
described for doors in paragraph 3-167.
(3) Remove left rear sliding door in similar
manner.
3-171. Left Hand Front Panel
(4) Install in reverse order.
Refer to paragraph 3-170 and remove or install left hand
b. Cleaning, Inspection, and Repair.
front panel in a similar manner.
(1) Clean door with an approved cleaning
solvent and dry thoroughly.
3-143
