(3) Repair
by
replacing
a
defective
b. Cleaning, Inspection, and Repair. Refer
transmitter or mounting hardware.
to paragraph 3-156 and clean, inspect, or repair starter
push switch in a similar manner.
3-154. Water Temperature Indicator
a. Removal and Installation.
3-158. Horn Push Switch
(1) Refer to figure 3-128 and remove the
a. Removal and Installation.
water temperature indicator.
(1) Refer to figure 3-119 and remove horn
(2) Install in reverse order.
push switch.
b. Cleaning, Inspection, and Repair.
(2) Install in reverse order.
(1) Clean indicator with a soft cloth
b. Cleaning, Inspection, and Repair. Refer to
dampened in an approved cleaning solvent and dry
thoroughly.
switch in a similar manner.
(2) Visually inspect indicator for dents, broken
glass, or other defect. Inspect mounting hardware for
3-159. Windshield Wiper Switch (Winterized
burs, stripped threads or other damage.
Units Only)
(3) Repair by replacing defective mounting
a. Removal and Installation.
hardware or water temperature indicator.
(1) Remove side panel from instrument
control pedestal.
3-155. Indicator (Warning) Light, Water High
(2) Tag and disconnect electrical leads and
Temperature
remove mounting hardware as required.
(3) Remove windshield wiper switch (fig. 2-
and remove indicator (warning) light water high
temperature. Install in reverse order.
b. Cleaning, Inspection, and Repair. Refer to
b. Cleaning, Inspection, and Repair.
Clean,
inspect, and repair indicator light in manner described in
similar manner.
3-160. Electrical Connector (Quick Disconnect)
3-156. Run-Shutdown Switch
Receptacle (855BG-2 or -3)
a. Removal and Installation.
a. Removal.
(1) Refer to figure 3-129 and remove run-
(1) Remove
electrical
connector
from
shut-down-toggle switch.
receptacle at bottom of instrument panel (fig. 2-23).
(2) Install in reverse order.
(2) Remove side panel from control pedestal.
b. Cleaning, Inspection, and Repair.
(3) Remove four nuts, lockwashers, and
(1) Clean switch in an approved cleaning
screws, then remove electrical connector receptacle
solvent and dry thoroughly with compressed air.
from bottom of control panel.
(2) Visually inspect switch for damaged or
b. Installation. Install by reversing procedure in a,
defect. Use multimeter and test for continuity between
above.
terminals when switch is ON. When switch is OFF, no
continuity should be indicated.
3-161. Terminal Board and Wiring
(3) Repair by replacing a defective switch.
a. Removal and Installation.
(1) Refer to figure 3-128 and remove terminal
3-157. Starter Push Switch
board.
a. Removal and Installation.
(2) Install in reverse order.
(1) Refer to figure 3-129
and
remove
starter push switch.
(2) Install in reverse order.
Section XXI. COUNTERWEIGHTS
3-162. General
counterweight extension is removed. This will
Warning: Do not travel over rough terrain
avoid danger of tipping the unit over, damaging the
with crane-shovel basic unit (without front end
equipment, or injury to personnel.
attachment), unless
3-140
