k. Disconnect clutch lever linkage from power take-
s. Install engine by reversing procedures given in a
off (TM 5-3810-201-12).
through r above.
I. Remove drive chain case and drive chain from
power take-off (TM 5-3810-201-12).
2-10. Revolving Frame Removal or Installation
m. Remove external coolant lines from oil pan on
a. Remove cab (para 2-7).
winterized models (TM 5-3810-201-12).
b. Remove counterweight (TM 5-3810-20112).
n. Remove two bolts (5, fig. 2-2), lockwashers (7),
and nuts (6) from front of engine and mounting base.
c. Remove vertical propelling gear and jaw clutch
o. Remove four nuts (15, fig. 2-4), lockwashers
(14), and bolts (16) from rear of engine and rear engine
d. Remove front and rear hook rollers (TM 5-3810-
support.
201-12).
p. Remove two nuts (11), bevel washers (10), and
e. Use a lifting device of sufficient capacity and
capscrews (12) from power take-off (2) and power take-
remove revolving frame (12, fig. 2-2) from crawler.
off support (9).
f. Install in reverse order.
q. Position lifting sling on engine in manner to avoid
damage of engine accessories or components.
2-11. Crawler Removal or Installation
r. Use a suitable lifting device and remove the
Remove revolving frame (para 2-10). Install in reverse
engine from revolving frame. Be careful, and assure that
order.
engine clears all obstructions of equipment on the
revolving frame.
2-11
