EMC 5-3810.207-35/17
1
Screw (4 rqr)
25
Pole shoe (4 rqr)
2
Lockwasher (4 rqr)
26
Lower field coil, right hand
3
Capscrew (6 rqr)
27
Screw (8 rqr)
4
Lockwasher (12 rqr)
28
Cover band
5
End cover
29
Screw (4 rqr)
6
Commutator end frame
30
Brush arm (4 rqr)
7
Bearing
31
Spacer
8
Lead
32
Brush spring (4 rqr)
9
Brush (4 rqr)
88
Nut (4 rqr)
10
Screw (5 rqr)
34
Armature
11
Lockwasher (28 rqr)
35
Inside retaining plate
12
Brush plate
36
Bearing
13
Field coil frame
37
Drive end frame
14
Screw (4 rqr)
38
Outside retaining plate
15
Receptacle
39
Screw (6 rqr)
16
Gasket
40
Collar
17
Spacer
41
Lockwasher (6 rqr)
18
Elbow
42
Fan
19
Screw (4 rqr)
48
Sheave
20
Dowel pin (2 rqr)
44
Cup
21
Lower field coil, left hand
45
Washer
22
Insulator (2 rqr)
46
Nut
23
Upper field coil, left hand
47
Screw (6 rqr)
24
Upper field coil, right hand
48
Screw (6 rqr)
Figure 3-1. Generator, exploded view.
b. Removal and Installation. Refer to TM 5-3810-
(2) Remove the four through bolts holding
drive end frame, stator, and slip ring end frame together.
201-12 and remove or install the alternator.
(3) Use one of the through bolts and lift the
c. Disassembly and Reassembly. Disassemble as
two brushes from slip ring.
(4) Remove drive end frame and rotor from
required to accomplish inspection and repair in the
stator and slip ring end frame.
following order.
(5) Separate slip ring end frame from stator
(1) Remove nut (fig. 3-2) and washer from
shaft, then remove pulley and fan. Remove key from
shaft.
AGO 20051A
3-2
