Figure 3-2. Alternator, disassembly and reassembly.
by prying electrical connector pins from their sockets in
(8) When it is necessary to remove
slip ring end frame.
unserviceable slip rings, unsolder field windings, then
(6) Use a soft hammer and tap rotor shaft
press slip rings off shaft.
from drive end frame and bearing.
NOTE
New slip rings must be pressed on
NOTE
rotor shaft by pressing on inner collar
If it is necessary to remove bearing
only, and field windings should be
by pulling on outer race, install a new
soldered with pure tin. New slip rings
bearing at reassembly. Press only on
must be turned in a lathe, in a manner
the inner race while installing the new
similar to that used to repair worn
bearing.
rings.
(7) Use a suitable puller and pull bearing from
(9) Remove retainer and bearings from drive
slip ring end of shaft.
end frame.
AGO 20051A
3-3
