(9) Support weight of shaft (9, fig. 5-8) and remove
(15) Remove two nuts (16), lockplate (17), capscrews
nuts (7), lockwashers (8), bearing cap (5), and bolts (6).
(10), and two halves of collar (9) from shaft (8).
(10) Remove bolt (81, fig. 5-6), bearing caps (21),
(16) Remove two sleeve bearings (1) from each
bearings (4, 7, and 18, fig. 5-9), and shims (88, 84, and
brakedrum (5).
51, fig. 5-6). Mark bearings and shims for reassembly in
proper position.
b. Clean, Inspection, aid Repair.
(11) Pull brakedrum (5) off each end of shaft (8).
(1) Clean all parts and dry thoroughly.
(12) Pull sprocket wheels (2) off brakedrums (5).
Remove key (8) from each brakedrum (5).
(2) Inspect brakedrums, jaw clutch, and adjusting
collar for cracks, breaks, or other damage. Inspect gear,
(18) Pull jaw clutch half (6) from each end of shaft
sprockets, and bearings for damage or excessive wear.
(8).
Inspect mounting hardware for burred threads or other
damage. Inspect gaskets for tears or deterioration.
(14) Press bevel gear (11) off shaft (8) and remove
Inspect shaft for straightness, out-of-round, worn bearing
keys (14).
surfaces, or other damage.
Figure 5-9. Horizontal propelling shaft,
AGO 20051A
5-10
