below throttle control lever (fig. 2-24) this control shuts
off fuel flow to injector pump. Pull to stop engine (para
aa. Steering Gear Engaging Lever. Located behind
steering wheel (fig. 2-24), this lever should always be
up as illustrated, except when steering wheel is to be
used. Moving lever downward engages steering wheel
with steering gear.
ab Swing Lock Lever. This lever type control for
locking machine so it will not swing during
transportation, or prolonged storage. Lever is illustrated
in the unlocked position. To lock, remove wedge; grasp
trigger lever and squeeze together while moving lever
forward. (It may require swinging machinery deck a little
left or right before the lock will engage ring gear). Let
wedge hang on its chain.
Note
Anti-rotation bars (para 2-5g) must
also be installed for transportation
and storage.
ac. Swing Brake Lever. Located between steering
wheel and pressure primer discharger (fig. 2-24), push
this lever forward to apply hydraulic pressure to swing
brake. To lock the swing brake, push lever forward and
set brake, then push swing brake hydraulic control
handle in and turn one quarter turns clockwise. Release
by turning counterclockwise 1/4 turn and pulling up.
ad. Swing and Propel Shifter Lever. This lever,
located at left of steering wheel (fig. 2-24) and along
side instrument control stand, shifts motive power to
propel or swing. Move shifter lever fully forward to
travel machine, fully to the rear for swing motion.
ae. Hoist Brake Lock. Turning this lever to the left
brake in applied position. Move right to release.
af. Digging Brake Lock. Moving this lever to right
brake in the applied position.
located on floor in front of lever stand, near instrument
control stand, applies brake to left hand or digging drum.
Figure 2-26. Heater control valves.
ah Hoist Brake Pedal. Located ,on floor in front of
(fig. 2-24) is used to set engine speed. Move forward to
lever stand to right of digging brake pedal (fig. 2-23),
increase speed, back to idle.
this pedal applies brake to right hand or hoist drum.
z. Manual Engine Shut Off Control. Located
shifter lever (ad above) will swing or
2-26
