b.
Cleaning, inspection, and repair.
b.
Used by Engine Model D333TA.
(1) Clean all parts with an approved
(1) Removal and installation.
Refer to
cleaning solvent and dry thoroughly.
sequence, then remove air cleaner from support bracket
(2) Visually inspect all parts for bends,
and turbocharger coupling. Install in reverse order.
cracks, other damage or defects.
(2) Disassembly and reassembly. Refer to
(3) Repair by straightening bends, welding
figure 346, disassemble air cleaner by removing items 4
cracks, or replacing damaged gaskets, defective
through 10 in numerical sequence. Reassemble in
manifold or mounting hardware.
reverse order.
c.
Installation. Install by reversing procedure
(3) Support
bracket
removal
and
described in a above.
12, then remove support bracket from engine. Install in
3-67. Fuel Tanks, Lines, and Fittings
reverse order.
a.
Removal and Installation. Refer to figure 3-
(4) Cleaning, inspection, and repair.
48 and remove fuel tank, lines, and fittings. Install in
(a) Clean all parts with an approved
reverse order.
cleaning solvent and dry thoroughly. Dry filter element
b.
Cleaning and inspection.
with, low pressure compressed air.
(1) Clean all parts with an approved
(b) Visually inspect all parts for
cleaning solvent and dry thoroughly.
damage, defect, or deterioration.
(2) Visually inspect all parts for cracks,
(c) Repair by replacing damaged or
breaks, or other damage. Inspect hardware for stripped
defective parts.
threads or other defect. Inspect fuel strainers for
(5) Service. Service dry type air cleaner as
breaks, tears of screen, or other damage. Inspect fuel
directed in paragraph 3-11.
tank for leaks.
Replace defective components or
mounting hardware.
3-66. Air Manifold (Blower to Blower) Engine Model
(3) Repair cracks and breaks by welding.
687C-18-ES
Repair a leaking tank as follows:
a.
Removal.
(a) Remove fuel tank (a above).
(1) Remove two hose clamps (fig. 3-47)
(b) Fill tank with water to avoid
from hose.
concentration of fumes.
(2) Remove eight capscrew, lockwasher,
(c) Weld leaking area.
and flatwasher, then remove blower-to-blower air
(d) Drain water from tank, blow dry as
manifold and gaskets from blower adapters.
possible with compressed air, then pour about gallon
of fuel oil into-tank and slosh it around
Figure 3-47. Air manifold and blower adapters, installed view.
3-60
