TM 5-3810-206-35
cover (4), gasket (5), and pin (6) from cover (7).
c. Cleaning, Inspection, and Repair.
Clean,
Remove studs (3, 37, and 38) when necessary.
inspect, and repair in a manner similar to that described
(7) Remove bolt (36) and stud (37) and
in paragraph 3-30c above, using table 1-1 for
lockwashers (2) from cover (7), then remove cover (7)
dimensional clearances and tolerances.
and gasket (8) from engine.
d. Installation. Install timing gear train and cover
(8) Remove bolt (9), retainers (10, 11, 16 and
by reversing the procedures covered in a and b above.
17), nut (14) and lockwasher (13), then remove plate
Align timing marks.
(12) and gasket (15).
e. Timing the Engine.
b. Timing Gear Train Removal. Remove timing
(1) Remove flywheel pointer cover from housing
gear train in a manner similar to that described in
then turn flywheel in direction of engine rotation until the
paragraph 3-30b above.
KEY to fig. 3-41:
1
Gasket
7
Gear
13
Nut
19
Spacer plate
24
Gasket
2
Plug
8
Bearing
14
Retainer
20
Bearing
25
Cover
3
Housing
9
Lock
15
Dowel
21
Washer
26
Plug
4
Gasket
10
Washer
16
Gear
22
Bolt
27
Bolt
5
Shaft
11
Spacer
17
Key
23
Bolt
28
Pin
6
Bolt
12
Screw
18
Lock
Figure 3-41. Accessory drive, exploded view.
3-50
