Section IV. CRANE WINTERIZATION EQUIPMENT

TM-5-3810-207-20 Crane-Shovel Basic Unit Truck Mounted: 20 Ton 3/4 Cu.Yd. Gasoline Driven (Quickway Model M-200) Non-Winterized Manual
Page Navigation
127

TM 5-3810-207-20/TO 36C23-3-37-12 Figure 105. Back hoe gantry sheaves, removal and installation. Section IV. CRANE WINTERIZATION EQUIPMENT 182. General The heater assembly, mounted in the crane-shovel cab, is used as a cold-weather, engine starting aid and, by the use of deflectors, hose, and controls, is used to heat the operator's cab, battery box, and window defrosters. The 24-volt electrical system furnishes the power to control the heater assembly either manually or by the use of thermostats. A fuel pump, lines, and fittings furnish fuel for the heater assembly. A radiator shutter is supplied and is also used as a cold-weather, engine starting aid. 183. Radiator Shutter a. Removal. Remove the radiator shutter as instructed on figure 106. b. Cleaning and Inspection. (1) Clean the radiator shutter with an approved cleaning solution. (2) Inspect the radiator shutter for breaks, bends, and other damage. Repair or replace damaged radiator shutter and mounting hardware as necessary. c. Installation. Install the radiator shutter as illustrated on figure 106. 184. Crane Heater Assembly a. Removal. (1) Remove the control box cover. (2) Remove the crane heater assembly as instructed on figure 107. b. Cleaning and Inspection. (1) Clean the heater and mounting hardware with an approved cleaning solvent and dry thoroughly. (2) Inspect the heater and mounting hardware for breaks, bends, and other damage. 147

Privacy Statement
Press Release
Contact