TM 5-3810-207-20/TO 36C23-3-37-12
Figure 130. Blackout service light, exploded view.
Measure the distance from the surface the
equipment is upon to the center of the
headlight; mark a horizontal line the same
distance on the vertical surface; mark
horizontal lines on the vertical surface as
illustrated on figure 135.
(3)
Remove the headlight door.
(4)
Turn the top screw in or out for vertical
adjustment and turn the side screw for
horizontal adjustment of the sealed beam.
Use a suitable cover and cover one
headlight while aiming the other.
(5)
Replace the headlight door.
232. Dome Light
a.
Removal. Remove the dome light as instructed
on figure 136.
b.
Cleaning and Inspection.
(1)
Clean all parts with a cloth dampened with
an approved cleaning solvent and dry
thoroughly.
(2)
Inspect all parts for breaks and other
damage.
(3)
Replace damaged parts as necessary.
c.
Installation. Install the dome light as illustrated on
figure 136.
233. Oil Pressure Sending Unit and Gage
a.
Removal. Remove the oil pressure sending unit
and gage as instructed on figure 137 and in paragraph
212.
b.
Cleaning and Inspection.
(1)
Clean all parts with a cloth dampened with
an approved cleaning solvent and dry
thoroughly.
(2)
Inspect all parts for leaks, breaks, and other
damage.
(3)
Replace damaged parts as necessary.
c.
Installation. Install the oil pressure sending unit
and gage as illustrated on figure 137 and as instructed in
paragraph 212.
234. Clearance. Marker Lights
a.
Removal. Remove the marker lights in a similar
manner as described in paragraph 88.
b.
Cleaning and Inspection. Clean and inspect the
marker lights (par. 88).
c.
Installation. Install the marker lights (par. 88).
235. Horn
a.
Removal. Remove the horn as instructed on
figure 138.
b.
Cleaning and Inspection.
(1)
Clean the horn. with a cloth dampened with
an approved cleaning solvent and dry
thoroughly.
(2)
Inspect the horn for proper operation.
Replace a defective horn.
c.
Installation. Install the horn as illustrated on
figure 138.
174
