b. Inspection and Repair. Inspect all parts for
219. Carrier Engine Distributor Assembly
excessive wear or damage. Replace or repair all
Removal and Disassembly
defective parts.
a. Removal. Remove the carrier engine distributor
assembly (TM 5-3810-207-20).
221. Carrier Engine Distributor Assembly
b. Disassembly. Disassemble the carrier engine
Reassembly and Installation
distributor assembly (par. 72).
a. Reassembly. Reassemble the carrier engine
distributor assembly (par. 74).
220. Carrier Engine Distributor Assembly
b. Installation. Install the carrier engine distributor
Cleaning, Inspection, and Repair
assembly (TM 5-3810-207-20).
a. Cleaning. Clean all parts with a dry, lint-free
cloth and compressed air.
Section VI. CARRIER ENGINE ACCESSORY DRIVE ASSEMBLY
224. Carrier Engine Accessory Drive
222. General
The carrier engine accessory drive assembly is
Assembly Cleaning, Inspection,
externally mounted on the left side of the carrier engine
and Repair
block. The accessory drive assembly is driven from the
a. Cleaning. Clean all parts with an approved
carrier engine camshaft gear by a helical gear which also
cleaning solvent and dry thoroughly.
drives the carrier engine oil pump assembly. The
b. Inspection and Repair. Inspect all parts for
distributor is mounted on top end of the accessory drive
excessive wear and damage. Replace or repair all
shaft. The drive shaft for the governor drive cable is also
defective parts.
mounted on the accessory drive housing and is gear-
driven from the accessory drive shaft.
225. Carrier Engine Accessory Drive
Assembly Reassembly and
223. Carrier Engine Accessory Drive
Installation
Assembly Removal and Disassembly
a. Reassembly. Reassemble the carrier engine
a. Removal.
accessory drive assembly in the reverse of the numerical
(1) Remove the carrier engine governor drive
sequence as illustrated on figure 54.
cable and distributor assembly (TM 5-
b. Installation.
3810-207-20).
(1) Install the carrier engine accessory drive
(2) Remove the carrier engine accessory
assembly as illustrated on figure 53.
drive assembly as instructed on figure 53.
(2) Install the distributor assembly and carrier
b. Disassembly. Disassemble the carrier engine
engine governor drive cable (TM 5-
accessory drive assembly in numerical sequence as
3810207-20).
illustrated on figure 54.
Section VII. CARRIER ENGINE RADIATOR ASSEMBLY
tanks are soldered to the core. The radiator filler is
226. General
welded into the upper tank and the overflow tube is
The carrier engine radiator assembly consists of an
soldered in the filler.
upper tank, core, and a lower tank. The upper and lower
TAGO 5030A
105
