b. Disassembly. Disassemble the carrier engine
approved cleaning solvent and dry thoroughly.
speed governor assembly in the numerical sequence as
illustrated on figure 52.
209. Carrier Engine Speed Governor
Assembly Reassembly and
208. Carrier Engine Speed Governor
Installation
Assembly Cleaning, Inspection,
a. Reassembly. Reassemble the carrier engine
and Repair
speed governor assembly in the reverse of the numerical
a. Cleaning. Clean all parts with an approved
sequence as illustrated on figure 52.
b. Installation. Install the carrier engine speed
cleaning solvent and dry thoroughly.
b. Inspection and Repair. Inspect all parts with an
governor assembly (TM 5-3810-207-20).
Section III. CARRIER ENGINE GENERATOR ASSEMBLY
assembly (TM 5-3810-207-20).
210. General
b. Disassembly. Disassemble the carrier engine
The carrier engine generator assembly is a 4-pole,
generator assembly (par. 60).
shunt-type unit with sealed ball bearings in both the drive
end frame and the commutator end frame.
The
212. Carrier Engine Generator Assembly
generator serves a dual purpose: it supplies electrical
energy for lights, ignition and accessories, and it serves
Cleaning, Inspection, and Repair
to recharge the batteries by furnishing current to make
a. Cleaning. Clean all parts with an approved
up for cranking and other power supplied by the batteries
cleaning solvent and dry: thoroughly.
while the generator is not in operation. The armature
b. Inspection and Repair. Inspect all parts for
rotates between field coils and produces voltage. The
excessive wear or damage. Replace or repair all
generator is cooled by a fan mounted on the drive pulley.
defective parts. Refer to TM 5-764 for armature and field
The generated current is discharged to the electrical
coil tests.
system through the armature and field terminals. The
generator rotates clockwise with a brush tension of 28
213. Carrier Engine Generator Assembly
ounces. The field current at 80 Fahrenheit is 1.00-1.05
Reassembly and Installation
amperes at 24 volts. The cold output of the generator at
a. Reassembly. Reassemble the carrier engine
4000 revolutions per minute is 40 amperes at 28 volts.
generator assembly (par. 62).
b. Installation. Install the carrier engine generator
211. Carrier Engine Generator Assembly
assembly (TM 53810-207-20).
Removal and Disassembly
a. Removal. Remove the carrier engine generator
Section IV. CARRIER ENGINE STARTER ASSEMBLY
torque, drawing 6.6 volts at 200 maximum amperes
214. General
when locked. The starting motor has 4 poles using 8
The carrier engine starter assembly is a heavy-duty
brushes and has an intermediate bearing to support the
type with an overrunning clutch drive. The starting motor
armature shaft in the middle, while the ends are
turns at 6X000 rpm, drawing 23.4 volts at 30 maximum
supported by bushings.
amperes with no load, and develops 20 foot-pounds of
TAGO 5030A
101
