Figure 82. Carrier cab and wiring harness, removal and installation.
g. Remove the windshield wiper motor and low
damage. Replace all defective parts.
pressure warning valve (TM 5-3810-20720).
h. Remove the cab door and window glass (TM 5-
301.
Carrier Cab and Wiring Harness Installation
3810-207-20).
i. Remove the cab toe floorboards (TM 53810-
a. Install the carrier cab and wiring harness as
207-20).
illustrated on figure 82.
j. Remove the carrier cab and wiring harness as
b. Install the cab toe floorboards (TM 53810-207-
instructed in figure 82.
20).
c. Install the cab door and window glass (TM 5-
300.
Carrier Cab and Wiring Harness Cleaning and
3810-207-20).
d. Install the windshield wiper motor and low
Inspection
pressure warning valve (TM 5-3810-20720).
a. Clean all parts with an approved cleaning solvent
e. Install the heater, control boxes, ducts, and cab
and dry thoroughly.
thermostat (TM 5-3810-207-20).
b. Inspect all parts for excessive wear and
f. Install the fuel priming pump (TM 53810-207-
20).
g. Install the steering wheel (TM 5-3810207-20).
TAGO 5030A
139
