1
Retainer ring
391.
Carrier Steering Hydraulic Cylinder Assembly
2
Cover plate
Removal and Disassembly
8
Packing
4
Screw, cap, 1/4-20 x 5/8 in. (2 rqr)
a. Removal.
Remove the carrier steering
5
Washer, lock, IT, 1/4 in. (2 rqr)
hydraulic cylinder assembly (TM 5-3810-20720).
6
End cover
7
Packing (2 rqr)
b. Disassembly. Disassemble the carrier steering
8
Nut, stop, 5/16-24
hydraulic cylinder assembly in numerical sequence as
9
Washer, special, 5/16 in.
illustrated on figure 109.
10
Flexure rod
11
Spool
392.
Carrier Steering Hydraulic Cylinder Assembly
12
Packing
Cleaning, Inspection, and Repair
13
Centering washer
14
Packing
a. Cleaning. Clean all parts with an approved
15
Centering washer
cleaning solvent and dry thoroughly.
16
Spring
17
Centering washer
b. Inspection and Repair. Inspect all parts for
18
Plug
excessive wear and damage. Replace or repair all
19
Packing
defective parts.
20
Spring
21
Ball
393.
Carrier Steering Hydraulic Cylinder Assembly
22
Screw, cap, 5/16 -18 x in. (4 rqr)
Reassembly and Installation
28
Washer, fiat, 5/16, in. (4 rqr)
24
Gasket
a. Reassembly. Reassemble the carrier steering
25
Actuating lever
hydraulic cylinder assembly in the reverse of the
26
Valve body
numerical sequence as illustrated on figure 109.
Figure 108.- Continued.
b. Installation. Install the carrier steering hydraulic
cylinder assembly (TM 5-3810-20720).
Section IV. CARRIER STEERING COLUMN AND GEAR ASSEMBLY
(5) Remove the carrier steering gear
394. General
assembly as instructed on figure 110.
The steering assembly used on the carrier is a cam
b. Disassembly. Disassemble the carrier steering
and lever type assembly. Manual operation of the
column and gear assembly in numerical sequence as
steering wheel causes the camshaft to rotate in the gear
illustrated on figure 111.
assembly.
396.
Carrier Steering Column and Gear Assembly
395.
Carrier Steering Column and Gear Assembly
Cleaning, Inspection, and Repair
Removal and Disassembly
a. Removal.
a. Cleaning. Clean all parts with an approved
solvent and dry thoroughly.
(1) Remove the steering wheel and horn (TM
5-3810-207-20).
b. Inspection and Repair. Inspect all parts for
excessive wear. Replace or repair all defective parts.
(2) Remove the steering gear arm and control
Inspect shims between lever shaft and housing. Adjust
valve (TM 5-3810-207-20).
shims pack to proper thickness. Shim pack should not
be able to be turned by fingers through side cover.
(8) Remove the turn signal switch (TM 5-
3810-207-20).
397.
Carrier Steering Column and Gear Assembly
(4) Remove two screws and clamp that
and Installation
secures the steering column to the
instrument panel. Remove clamp bolt
a. Reassembly. Reassemble the carrier steering
from top cover of the gearbox and remove
column and gear assembly in the reverse of the
the steering column.
numerical sequence as illustrated on figure 111.
TAGO 5030A
179
