1
Screw, cap, 3/8-16 x 2 in. (2 rqr)
10
Packing
19
Adapter
2
Stud and nut assembly 3/8 -16-24 x 3 1/8 in. (3 rqr)
11
Bushing
20
Gasket
3
Cover body
12
Packing
21
Flow director
4
Dowel pin (8 rqr)
13
Shaft
22
Snap ring
5
Valve cap
14
Dowel pin
23
Bearing
6
Packing
15
Cam ring
24
Seal
7
Spring
16
Roll (6 rqr)
25
Bushing
8
Valve assembly
17
Carrier
26
Base body
9
Tube seat
18
Drive pin
Figure 107. Carrier steering hydraulic pump assembly, exploded view
b. Inspection and Repair. Inspect all parts for
387.
Carrier Steering Hydraulic Control
Valve
excessive wear and damage. Replace or repair all
Assembly Removal and Disassembly
defective parts.
a. Removal. Remove the carrier steering hydraulic
389.
Carrier Steering Hydraulic Control
Valve
control valve assembly (TM 5-3810207-20).
Assembly Reassembly and Installation
b. Disassembly. Disassemble the carrier steering
a. Reassembly. Reassemble the carrier steering
hydraulic control valve assembly in numerical sequence
hydraulic control valve assembly in the reverse of the
as illustrated on figure 108.
numerical sequence as illustrated on figure 108.
388.
Carrier Steering Hydraulic Control Valve
b. Installation. Install the carrier steering hydraulic
Assembly Cleaning, Inspection, and Repair
control valve assembly (TM 5-3810207-20).
a. Cleaning. Clean all parts with an approved
cleaning solvent and dry thoroughly.
Section III. CARRIER STEERING HYDRAULIC CYLINDER ASSEMBLY
390. General
The carrier steering hydraulic cylinder assembly is a steering aid attached to the mechanical steering mechanism.
The hydraulic steering cylinder enables the operator to have effortless control of the carrier under all adverse conditions
that may be due to excessive loads or road conditions.
TAGO 5030A
177
