Figure 110. Carrier steering gear assembly, removal and installation.
b. Disassembly. Disassemble the carrier steering
removed there should be a small amount of drag in
rotating the steering knuckle, but it should not bind.
knuckle and shaft assembly in numerical sequence as
Replace or repair all defective parts.
illustrated on figure 113.
401.
Carrier Steering Knuckle and Shaft Assembly
400.
Carrier Steering Knuckle and Shaft Assembly
Reassembly and Installation
Cleaning, Inspection, and Repair
a. Reassembly. Reassemble the carrier steering
a. Cleaning. Clean all parts with an approved
knuckle and shaft assembly in the reverse of the
cleaning solvent and dry thoroughly.
numerical sequence as illustrated on figure 113.
b. Inspection and Repair. Inspect all parts for
b. Installation.
excessive wear and damage. The proper adjustment of
the steering knuckle flange bearings is accomplished by
(1) Install the carrier steering knuckle
the shims located under the flange bearing caps.
Remove shims under each cap until there is no end play
in the knuckle assembly. After 0.005 inch shims is
TAGO 5030A
181
