1
Screw, machine, 1/4 -20 x 5/8 in. (4 rqr)
10
Pin, cotter, 1/8 x 1 1/4 in.
2
Washer, lock, 1/4 in. (4 rqr)
11
Nut, 3/4 -16
3
Cover
12
Piston ring (2 rqr)
4
Retaining ring
13
Piston
5
Seal
14
Nut, 5/8 -18
6
O-Ring
15
Washer, lock 5/8 in.
7
Bearing
16
Screw, cap, 5/8-18 x 2 3/4 in.
8
O-Ring
17
Clamp
9
Piston rod
18
Cylinder
Figure 109. Carrier steering hydraulic cylinder assembly, exploded view.
b. Installation.
(3) Install the turn signal switch (TM 53810-
207-20).
(1) Install the carrier steering gear assembly
as illustrated on figure 110.
(4) Install the steering gear arm and control
valve (TM 5-3810-207-20).
(2) Install the steering column and secure with
top cover clamp bolt.
Secure to
(5) Install the steering wheel and horn (TM 5-
instrument panel with clamp and two
3810-207-20).
screws.
Section V.
CARRIER STEERING KNUCKLE AND SHAFT ASSEMBLY
a. Removal.
398. General
The carrier steering knuckles are the trunnion
(1) Remove the front wheels (TM 53810-207-
socket-type with universal joints. The power is delivered
20).
through the differential to the axle shafts and out through
the constant velocity universal joints to the wheels. The
(2) Remove the brakeshoes (TM 5-3810207-
front axle can be engaged to operate as a driving unit or
20).
disengaged to rotate freely by operating the control lever
in the operator's cab. The trunnion sockets are provided
(3) Remove the tie rod drag links (TM 53810-
for the front axle to allow steering of the carrier while
207-20).
engaged or disengaged.
(4) Remove the carrier steering knuckle and
399. Carrier Steering Knuckle and Shaft Assembly
shaft assembly as instructed on figure
Removal and Disassembly
TAGO 5030A
180
