Figure 164. Continued.
wire from the lamp connects to a
(3) To install the light socket and receptacle
receptacle mounting nut.
assembly, insert the light socket through
the hole in the angle bracket (28) and
install the internal mounting nut. Place
267. Engine Heater Assembly
the light socket in mounting position on
the panel and fasten with the external
a. Removal and Installation. Remove and install
mounting nut. Allow for "press-to-test"
carrier engine heater assembly as instructed on figure
button movement by adjusting the light
socket mounting position. Install the lamp
and button.
b. Cleaning and Inspection.
(4) Fasten the receptacle to the angle bracket
(1) Clean the heater and mounting hard
with the mounting screws, washers, and
nuts. Connect the wires according to the
wiring diagram (fig. 164). The ground
AGO 6819A
180
