(2) Inspect door for bends, dents, or broken
hinges. Replace a defective door as
necessary.
(3) Repair or replace damaged parts as
necessary.
c. Installations. Install the carrier cab operator's
door as illustrated on figure 157.
256. Cab Floorboard
a. Removal
(1) Remove floor mat.
(2) Remove the screws mounting the
floorboard to the frame.
(3) Remove the floorboard from the frame.
Figure 158. Windshield wiper motor and low-
b. Cleaning, Inspection, and Repair.
pressure signal, removal and installation.
(1) Clean all parts with an approved cleaning
solvent.
(2) Inspect floorboard for bends, cracks, rust,
and other damage.
(3) Replace or repair all defective parts as
necessary.
c. Installation.
(1) Position the floorboard on the frame.
(2) Install the screws in the floorboard,
securing the floorboard to the frame.
(3) Install the floormat.
257. Windshield Wiper Motor and Automatic Low-
Pressure Signal
a. Removal and Installation.
Figure 159. Engine hood and side panel, removal
(1) Remove and install windshield wiper
and installation.
motor assembly as instructed in figure
(2) Remove the engine hood and side panel
(2) Remove and install low-pressure Wig-
as instructed in figure 159.
Wag signal as instructed in figure 158.
b. Cleaning, Inspection, and Repair.
b. Cleaning and Inspection.
(1) Clean all parts with an approved cleaning
(1) Clean all parts with an approved
solvent.
cleaning solvent and dry thoroughly.
(2) Inspect the hood panels for cracks or
(2) Inspect for cracks, breaks, and proper
dents. Pound out dents and weld all
operation.
cracks as necessary.
(3) Replace a damaged or defective
(3) Repair or replace damaged parts as
windshield wiper motor or low-pressure
necessary.
signal as necessary,
c. Installation.
258. Engine Hood and Side Panel
(1) Install the engine hood and side panel as
a. Removal.
illustrated on figure 159.
(1) Remove the battery cables and box (para.
(2) Install the battery box and cables (para.
AGO 6819A
175
