(1) Install the crane engine piston and
357.
Crane Engine Piston and Connecting Rod
connecting rod assemblies in the,
Assemblies Reassembly and Installation
engine block in the reverse of the
instructions on figure 198.
a.
Reassembly. Reassemble the crane engine
piston and connecting rod assemblies in the reverse of
(2) Install the crane engine cylinder head
the sequence as illustrated on figure 199.
b.
Installation.
(3) Install the crane engine oil pan (para.
849).
Section XVIII. CRANE ENGINE FLYWHEEL AND FLYWHEEL HOUSING
360.
Crane Engine Flywheel and Flywheel
358.
General
Housing Cleaning, Inspection and Repair
The crane engine flywheel is attached to the
crankshaft flange at the rear of the crane engine. A
a.
Cleaning. Clean all parts with an approved
flywheel ring gear that meshes with the starter pinion to
cleaning solvent and dry thoroughly.
turn the engine over is shrunk on the forward surface of
b.
Inspection and Repair. Inspect all parts for
the flywheel. The housing also bolts to the clutch
excessive wear and damage. Replace or repair all
housing.
defective parts. With an approved indicator check the
flywheel run-out and counterbore. In both cases the
359.
Crane Engine Flywheel and Flywheel
maximum indicator reading must not exceed 0.008 inch.
Housing Removal and Disassembly
361.
Crane Engine Flywheel and Flywheel
a.
Removal.
Housing Reassembly and Installation
(1) Remove the starter (para. 129).
a.
Reassembly. Reassemble the flywheel and
(2) Remove the crane engine (para. 297).
flywheel housing in the reverse of the numerical
(3) Remove the crane engine clutch (para.
sequence as illustrated on figure 201.
886).
b.
Installation.
(4) Remove the flywheel and flywheel
(1) Install the flywheel and flywheel housing
housing as instructed on figure 200.
as illustrated on figure 200.
b.
Disassembly. Disassemble the flywheel and
(2) Install the crane engine clutch (para.
ring gear in numerical sequence as illustrated on figure
(3) Install the crane engine (para. 297).
(4) Install the starter (para. 129).
AGO 6819A
221
