b.
Inspection and Repair. Inspect all parts for
535.
Carrier Steering Hydraulic Control Valve
excessive wear and damage. Replace or repair all
Assembly Removal and Disassembly
defective parts.
a.
Removal.
Remove the carrier steering
hydraulic control valve assembly (para. 217).
537.
Carrier Steering Hydraulic Control Valve
b.
Disassembly.
Disassemble the carrier
Assembly Reassembly and Installation
steering hydraulic control valve assembly in numerical
a.
Reassembly.
Reassemble the carrier
sequence as illustrated on figure 259.
steering hydraulic control valve assembly in the reverse
of the numerical sequence as illustrated on figure 259.
536.
Carrier Steering Hydraulic Control Valve
b.
Installation.
Install the carrier steering
Assembly Cleaning, Inspection and Repair
hydraulic control valve assembly (para. 217).
a.
Cleaning. Clean all parts with an approved
cleaning solvent and dry thoroughly.
Section LXIII. CARRIER STEERING HYDRAULIC CYLINDER ASSEMBLY
540. Carrier Steering Hydraulic Cylinder Assembly
538- General
The carrier steering hydraulic cylinder assembly is a
Cleaning, Inspection and Repair
steering aid mounted on the top side of the steering gear
a.
Cleaning. Clean all parts with an approved
assembly. The hydraulic steering cylinder enables the
cleaning solvent and dry thoroughly.
operator to have effortless control of the carrier under all
b.
Inspection and Repair. Inspect all parts for
adverse conditions that may be due to excessive loads
excessive wear and damage. Replace or repair all
or road conditions.
defective parts.
539. Carrier Steering Hydraulic Cylinder Assembly
541. Carrier Steering Hydraulic Cylinder Assembly
Removal and Disassembly
Reassembly and Installation
a.
Remove and disassemble the carrier steering
Reassemble and install the carrier steering
hydraulic cylinder assembly in numerical sequence as
hydraulic cylinder assembly in the reverse of the
shown in figure 259.
numerical sequence as illustrated on figure 259.
Section LXIV. CARRIER STEERING COLUMN AND GEAR ASSEMBLY
(2) Remove the steering gear arm (para. 221).
542. General
(3) Remove the turn signal switch (para. 122).
The steering assembly used on the carrier is a cam and
(4) Remove the screws and clamp that secure the
lever type assembly. Manual operation of the steering
steering column to the instrument panel. Disconnect the
wheel causes the camshaft to rotate in the gear
universal shaft to the steering gear and remove the
assembly.
steering column.
(5) Remove the carrier steering gear assembly as
543. Carrier Steering Column and Gear
instructed on figure 258.
Assembly Removal and Disassembly
a. Removal.
(1) Remove the steering wheel (para. 219).
AGO 6819A
290
