b. Cleaning and Inspection.
(1) Clean parts with a damp cloth.
(2) Inspect for defects and damage.
(3) Replace defective or damaged unit.
c. Installation. Install oil pressure sending unit and
4-88. Water Temperature Sending Units a. Removal.
(1) Drain cooling system.
(2) Remove water temperature sending units
b. Cleaning and Inspection.
(1) Clean parts with a damp cloth.
(2) Inspect for defects and damage.
(3) Replace defective or damaged sending
unit.
c. Installation.
(1) Install water temperature sending units as
(2) Fill cooling system as instructed in
paragraph 3-21.
4-89. Slave Receptacle
a, removal Remove slave receptacle as illustrated in
Figure 4-833. Crane engine water temperature sending
units, removal and installation
Figure 4-84. Crane slave receptacle, removal and installation.
4-87