b. Adjust the adjusting bars and nut and capscrew
the same manner as the left hand swing shaft clutch
to allow approximately 1/32 inch clearance between
bands.
band and stops with clutch engaged. The band lining
should never be allowed to drag on the drums, when
4-101. Auxiliary Shaft Clutch Bands (Power Load
clutch is fully disengaged.
Lowering)
a. Engage clutch by toggling in lever.
4-100.
Independent Boom Hoist Clutch Bands
b. Use a feeler gage to set distance between dead
end setscrew (fig. 4-90) on spider and band (not lining)
Adjustment
at 0.010 inch.
Adjust the independent boom hoist clutch bands in
c. Tighten locknuts
.
Figure 4-90. Auxiliary clutch adjustment.
4-94
