3-25. Cleaning, Inspection and Repair
3-26. Reassembly and Installation
a. Clean all parts with an approved cleaning solvent
a. Reassembly.
Refer to figure 3-11 and
and dry thoroughly.
reassemble the air compressor assembly.
b. Inspect all parts for excessive wear and damage.
b. Installation.
c. Replace or repair damaged or defective parts.
(1) Install air compressor as shown in fig. 3-
NOTE
Align timing marks on air compressor
drive gear with marks on camshaft gear.
(2) Refill cooling system.
Section IX. CARRIER ENGINE FAN CLUTCH AND DRIVE ASSEMBLY
3-28. Carrier Engine Fan Clutch and Drive Assembly
3-27. General
(Model 2380)
Both crane Models the 2380 and the 2385 are equipped
a. Removal and Disassembly.
with a carrier engine fan.
a. Model 2380. The fan is separately mounted and
(1) Remove carrier engine cooling system
clutch driven by a propeller shaft.
(TM 5-3810-232-12).
b. Model 2385. The fan is separately mounted and
(2) Remove and disassemble fan clutch and
drive assembly as instructed on figure 3-12.
driven by a hydraulic motor. A thermostatic control
operates the hydraulic fan drive motor.
Figure 3-12. (1) Fan clutch and drive assembly, removal, disassembly, reassembly and installation. Model 2380
3-25
