d Refer to TM 5-764 for armature and field coil
4-10. Cleaning, Inspection and Repair
tests.
a Clean all metal parts with an approved cleaning
solvent and dry thoroughly.
b Remove all dust, dirt, and foreign matter from
4-11. Reassembly and Installation
the frame and fields using compressed air.
a Reassembly.
Refer to figure 4-2
and
c Inspect all parts for excessive wear or other
reassemble the starting motor assembly.
damage. Repair or replace all defective parts.
b Installation. Refer to TM 5-3810-232-12.
Section IV. CRANE BATTERY CASE ASSEMBLY
b Inspect all parts for defects or damage. Repair
4-12. Removal
all defective parts.
Remove the battery case. (TM 5-3810-232-12).
4-14. Installation
4-13. Cleaning, Inspection and Repair
Install the battery case. (TM 5-3810-232-12).
a Clean all parts with an approved cleaning solvent
and dry thoroughly.
Section V. CRANE WIRING HARNESS
d. Remove wiring harness.
4-15. General
The wiring harness covered in this section include all
4-17. Repair
wiring harness assemblies used in the crane assembly.
Wire size and length of wire are given in TM 5-3810-232-
Repair defective wires in wiring harness.
35P.
4-18. Installation
4-16. Removal
a Note tags and connect all electrical leads
a Tag and disconnect all electrical leads.
and connectors.
b Tag and disconnect all electrical connectors.
b Connect all clamps and straps.
c Disconnect all clamps and straps, noting
location.
Section VI. CRANE ENGINE FUELPUMP AND GOVERNOR ASSEMBLY
4-19. General
4-20. Removal and Disassembly
The fuel pump assembly incorporates the governor
a Removal. Remove the fuel pump as illustrated
assembly and is flange mounted to the engine gear case
in figure 4-3.
and is driven from the engine gear train. The fuel pump
b Disassembly. Refer to figure 4-4 and d the fuel
draws fuel from the supply tank and delivers it at correct
pump assembly.
pressure and amount to the injectors for each cylinder.
4-5
