4-3. Cleaning, inspection and Repair
4-4.Reassembly and Installation
a Clean all metal parts with an approved cleaning
a Reassernbly.
Reassemble the generator in
solvent and dry thoroughly.
reverse of the numerical sequence as illustrated on
b Remove all dust, dirt and foreign matter from the
frame and fields with compressed air.
b Installation. Refer to TM 5-3810-232-12.
c Inspect all parts for excessive wear or damage.
Repair or replace defective parts.
Section II. CRANE GENERATOR REGULATOR
4-5. Removal
4-7. Installation
Remove the crane engine generator regulator as
Install the regulator as described in paragraph 3-7.
described in paragraph 3-5.
4-6. Adjustment
Adjust regulator as
described
in
Section III. CRANE ENGINE STARTING MOTOR
4-8. General
4-9. Removal and Disassembly
The starter is a 24-volt, 4-brush, gear drive type. The
a Removal. Refer to TM 5-3810-232-12.
starter converts the electrical energy of the batteries into
b Disassernmbly.
Refer to figure 4-2 and
the mechanical energy necessary to crank the engine.
disassemble the starting motor assembly.
NOTE
Do not disassemble the relay solenoid as this is a
replace item only.
4-3
