two bolts in threaded holes in adapter. Turn bolts evenly
(117), gear (52), sleeve (55), ball (49) and ring (53) from
and remove adapter.
sleeve (54). If snap ring is tight, threaded holes are
(8) Lock output gears (19) with a soft bar
provided to pull same from sleeve.
and remove output flange nut (13). Remove washer
(11) Remove plugs (23, 26, 27, 59), cover
(11), O-ring (14), and flange (10). Remove rear housing
(57, 61) and the downstream pressure regulating valve
cover screws (77), lockwashers (78) and pin (79).
assembly (25) from the converter housing (24).
Remove rear cover (41). Remove bearing cup (40) and
Disassemble the downstream pressure regulating valve
bring (42) from rear cover.
Remove screw (73),
as shown in part B of figure 5-2.
lockwasher (74), cover (75) and gasket (76) from rear
(12) Remove impeller and baffle assembly
cover.
(114, 92) from impeller hub (115). Remove screws (121)
(9) Remove studs (7), lockwashers (8) and
and washers (120) and remove flywheel ring gear bag
nuts (9). Remove the output shaft bearing cap (16), oil
assembly from impeller (114). Remove O-ring (148)
seal (15) shims (17). Using a split puller remove output
from flywheel ring gear bag assembly. Remove spacer
shaft (18) and rear bearing cone (4). Remove bearing
(85), bearing (86), 0-ring (87) and snap ring (116) from
cup (5) and bring (6). Remove output gear (19), front
impeller hub (116). Remove roll pin (117) from spacer
bearing spacer (3), front bearing cone (20), bearing cup
(85). Remove bring (113), screw (91) and plate (90)
(2), snap ring (21), oil baffle (1) and oil tube (22) from
from impeller (114). Remove oil seal (93) from oil baffle
rear cover.
(92). Remove pump driven gear snap ring (83), gear
(10) Remove turbine shaft (44), ring (47),
(82) and bearing (81). Remove snap rings (108, 109),
bearing cones (45, 65) and gear (43) from converter
bearing (94), and washers (95, 96). Using a soft bar tap
housing (24). Remove three oil baffle retainer screws
pump shaft assemblies (80) from converter housing.
(112) and washers (111, 110) from housing. Remove
(13) Remove screws (50) from sleeve (54).
the snap ring (118). Remove reaction member (84),
Remove sleeve (54). If inner turbine shaft bearing cup
spacer (85), bearing (86), snap rings (51, 116), roll pin
(46) is to be replaced, remove using suitable puller.
5-3
