c. Cleaning, Inspection and Repair.
Key to Figure 5-43 (1)
1
Nut
(1) Clean all metal parts with an approved
2
Grease fitting
cleaning solvent and dry thoroughly.
3
Bolt
(2) Inspect rod, pistons and cylinder for
4
Lockwasher
cracks, scoring and excessive wear. Repair or replace
5
Stop plate
defective parts.
6
Flat head screw
(3) Inspect packing, O-rings, and seals.
7
Lockwasher
Replace as necessary.
d. Reassembly.
8
Bearing retainer
9
Bearing
(1) Model 2380. Reassemble the outrigger
10
Bearing housing
cylinders in reverse of the numerical sequence shown on
11
Pipe plug
12
Cotter pin
(2) Model 2385. Reassemble the outrigger
13
Nut
cylinders in reverse of the numerical sequence shown of
14
Mounting
15
Retaining ring
NOTE
16
Washer
When reassembling tighten capscrew
17
Spring
(18, fig. 5-42B) to 50-60 foot-pounds
18
Cylinder weldment
19
Stop ring
e. Adjustment. To adjust packing assembly model
20
Snap
2385.
21
Snap ring
(1) Remove capscrew (14) figure 5-42B.
22
Tube
(2) Tighten packing nut (16) the required
23
Plug
amount to align capscrew hole in packing nut (16) with
24
Snap ring
the tapped holes in retainer (20). These holes are
25
Scraper
radially in line at 45 intervals. When packing nut is tight
26
Wiper
against packing (21) advancing capscrew one position
27
Seal retainer
(45) will increase packing compression 0.011 inch.
28
Seal
(3) Install locking capscrew and tighten
29
Roll pin
securely.
30
Piston rod
f. Installation. Install outrigger cylinders (TM 5-
31
Rod
3810-232-12).
32
Piston ring
33
Piston
5-32. Axle Hydraulic Steering Cylinders
34
Piston
a. Removal. -Remove axle steering cylinders (TM
5-3810-232-12).
(b) Disassembly. Disassemble the axle steering
cylinders in the numerical sequence shown on figure 5-
5-90
