TM 5-3810-288-12
1. Stud, fan bracket
11.
Washer, lock
21.
Bearing, ball
2. Bracket fan
12.
Belt, fan (3)
22.
Ring, retaining
3. Bolt, fan belt adjusting
13.
Spacer, fan
23.
Seal, oil
4. Nut, hex
14.
Gasket, fan spacer
24.
Shaft, fan drive
5. Bracket, fan hub
15.
Nut, flex loc
25.
Pin, taper
6. Washer, plain
16.
Bearing, ball
26.
Screw, cap, hex head
7. Washer, lock
17.
Washer
27.
Nut, hex
8. Bolts, mounting
18.
Spacer, ball bearing
28.
Washer, lock
9. Fan
19.
Plug, pipe, slotted headless
10. Screw, cap
20.
Sheave, fan
Figure 7-32. Fan, fan belt, and associated parts, removal and replacement.
(a) Refer to figure 7-33, remove the cap nut, and drain
the fluid from the hydraulic reservoir into a suitable
container.
(b) Refer to figure 7-34, loosen the jam nut and back off
on the power steering adjusting bolt to relieve power
steering pump belt tension. Lift the power steering
belt off the belt sheave.
(c) Refer to figure 5-3 and disconnect the fitting and
hose clamp which secure the lines to the pump and
pump reservoir, respectively.
(d) Refer to figure 7-35, remove the attaching bolts,
nuts, and lockwashers, and remove
7-39
