TM 5-3810-288-12
(2) Installation. Refer to figure 7-36 and install the drag
link. When tightening slotted plug, tighten the plug until it
is snug. Then, back off until the slot lines up with the
cotter pin. Install the cotter pin. Connections at the
steering arm end of the drag link are the same.
f.
Tie Rod.
(1) Removal. Remove the tie rod as follows:
(a) Block the tie rod so that it can not fall.
(b) Refer to figure 7-7 and remove the cotter pin,
nut, and tie rod pin. Remove the tie rod.
(2) Replacement. Refer to figure 7-37 and replace the
tie rod.
g. Shock Absorbers.
(1) Removal Refer to figure 7-38, and re-move the
shock absorbers.
(2) Installation. Refer to figure 7-38 and install the
shock absorbers.
Figure 7-36. Drag link, removal and replacement.
Figure 7-38. Shock absorbers, removal and
replacement.
Figure 7-37. Tie rod, removal and replacement.
7-42
