TM 5-3810-289-12
b. Inspect the equipment against the packing
list. Report discrepancies to proper authority.
2-3.
Installation or Setting Up Instructions
a. Installation
of
Separately
Packed
Components.
(1) Counterweight.
Install
the
counterweight into position at the rear of the cab as
Caution: The counterweight weighs 700
pounds.
Use suitable hoisting equipment and
caution when installing.
boom installation.
(3) Boom angle indicator. Refer to figure
2-2 and assemble the boom angle indicator to the lower
boom section.
A.
CRANE,
DRAGLINE,
CLAMSHELL
AND
for hook block installation.
BACKHOE
OPERATING
LEVER
b. Setting Up Instructions for Crane Operation
CONFIGURATION.
(1) Description of equipment required.
(2) Installation of separately packed
components. Refer to paragraph a., above.
(A) and change operating lever linkage, if not in correct
configuration, as follows:
(b) Remove pin securing reach rod
(5) to lever (3); remove reach rod (5), place or lever (4)
and install pin.
(c) Remove capscrews (10) securing
lever extension (8) to short lever extension (6) Insert
capscrew (10) through short lever (9) and secure lever
extension (8) to short lever (9)
(d) Middle lever (1) now controls real
drum reach rod (5) and hoist lever (2) controls front drum
reach rod (7).
(B) and change operating pedal linkage, if not in correct
B.
SHOVEL
OPERATING
LEVER
configuration, as follows:
CONFIGURATION.
(a) Disconnect long reach rod (2) and
ME 381028912/23
short reach rod (1) at brake pedals. Remove levers (6)
1 Middle lever
and (7) from shafts (3) and (4) by loosening clamping
2 Hoist lever
bolts. (8).
3 Short lever
(b) Remove spacer from shaft (3) and
4 Lever
install on shaft (4).
5 Rear drum reach rod
(c) Install lever (6) on shaft (3) and
6 Short lever extension
lever (7) on shaft (4). Tighten clamping bolts (8).
7 Front drum reach rod
(d) Connect long reach rod (2) and
8 Lever extension
short reach rod (1) to brake pedals.
9 Short lever
(e) Right pedal controls front drum
10 Capscrews
brake and left pedal controls rear drum brake.
Figure 2-3. Operating levers.
2-5