manually, it is usually more convenient to remove these
Note. This swing-and-propel clutch can be
units from the left and right as described below as the
removed as a unit by disconnecting the shifter yokes as
elevation of the shaft permits sufficient clearance. When
described in previous paragraph, loosening the driver
the shaft is finally removed through the left door, it then
bolt, wedging open the split hub and sliding the entire
carries only the hoist gear and left bearing.
assembly to the left off the shaft
(b) Disassembly
instructions
are
(2) Gears and left bearing
presented is two sections: Disassembly to the right,
(3) Rear drum clutch.
dissasembly to the left.
Note. This clutch can alos be removed from
(c) Either sequence may be taken first.
housing as a unit on ground or after raising shaft so
For instance to replace the swing gear, start with the second
clutch clears frame.
section and leave the assemblies to the right on the shaft,
(4) Right shaft bearing.
disassembling only to the point necessary for removal of the
d. Stripping After Removal From Machine
swing clutch housing with gear mounted on its hub from the
machine.
(1) General.
(2) Disassembly operations to the right.
(a) These stripping operations are after
(a) Pull off right shaft bearing housing
maximum disassembly of units as described in preceding
and bearing which is a light tap fit. Take care to protect
paragraphs. In other words the shaft is now free and
bearing shield from damage. Remove bearing housing by
carrying only those parts which must be pulled off from the
tapping lightly.
ends of the shaft itself. Where shaft is being removed
4-12
