SECTION II
CONTROLS AND OPERATION
REEVING
Reeving diagrams for the main hoist line are shown in
Figure 2-14. The number of parts of line (from one to
seven) used in reeving the main hoist line will depend on
the load to be lifted. Refer to the rating chart in the upper
cab to determine reeving requirements for various loads.
Hoisting and lowering speeds decrease as the number of
parts of line increases.
When practical, use the
minimum number of parts required for the loads to be
lifted.
Boom reeving diagram for clamshell operation is shown
Figure 2-13. Securing Rope to Drum
NOTE
Jib reeving is limited to a single part
Slowly wind the rope onto the winch drum by moving the
of line. The main or auxiliary winch
winch lever to the raise position. A lead or brass
line can be used to reeve the jib. The
hammer may be useful in tapping the rope over as it is
auxiliary winch line cannot, however,
being wound on the drum. Do not use a steel hammer or
be used for reeving the main hoist
pinch bar. These can readily cause damage to the rope
line.
Figure 2-14. Reeving Diagram (105N416)
Change 1 1-2-22