TM 5-3810-294-34
f. Remove oil seal (10). Remove capscrews (8)
a. Remove nut (1, fig. 5-7), lockwasher (2),
and lockwashers (9) and remove retainer (11) and
and keyed washer (3). Remove items (14, 15, and
gasket (12).
16).
g. Remove bearing (27) using a suitable puller.
b. Using a suitable puller, pull bearing (4) from
Remove retainer (26) and seal (25).
shaft 121).
h. Pull gear (24) from shaft (21).
c. Remove retainer 15) with oil seal (6). Remove
i. Press shaft (21) out of drum (18) as shown.
seal (f)) from the retainer and discard the oil seal.
The shaft must be pressed out from left to right.
d. Remove clutch assembly (7) as a unit.
Bearing (22) and seal (23) come out on the shaft.
e. Figure 5-8 illustrates disassembly and
Remove bearing and seal from the shaft. Remove
assembly of the rear drum clutch. The front drum
bearing (13) from opposite end of drum (18).
clutch is identical, except that spider (26) is op-
posite due to opposite drum rotation. Procedures
apply to both front and rear drum clutches.
Figure 5-8. Front and rear drum clutch assembly exploded view.
5-17
