TM 11-5895-1551-23P
b. Installation.
(5) Adjust clutch control linkage (refer to TM 5-
(1) Refer to figure 11-3 and install transmission
3810-294-20).
assembly.
11-10. Transfer Case
Note. Center clutch in flywheel housing
a. Removal
using a dummy shaft fir clutch installation tool shaft of
(1) Refer to TM 5-3810-294-20 and perform
the same diameter as the transmission input shaft. If a
the following operations:
spare transmission input shaft -is available, this would
(a) Disconnect front front axle, and intermediate
also serve to center the clutch (para 14-17). Move the
propeller shafts from transfer case.
transmission forward and enter the input shaft into the
(b) Disconnect transfer case controls from transfer
clutch bore.
case.
(c) Drain lubricant from transfer case.
(2) Connect front propeller shaft to drop gear
(2) Place a roller jack or similar support under
unit, and install front axle propeller shaft (refer to TM 5-
transfer case.
3810-294-20).
(3) Refer to figure 11-4 and remove transfer
(3) Fill transmission and drop gear unit with
case.
lubricant specified in the lubrication chart (refer to T'M 5-
3810-294-20).
(4) Install transmission cover and secure with
four flat washers, lockwashers and bolts.
Figure 11-4. Transfer case, removal and installation
11-8
