TM 5-3810-294-34
14-3. Cleaning, Inspection and Repair
KEY to fig. 14-1.
14.
Bracket
1. Nut (2)
15.
Lubrication fitting
a. Clean all parts with an approved cleaning solvent.
2. Lockwasher (2)
16.
Capscrew (4)
b. Inspect for wear or damage, and replace all defective
3. Pedal
17.
Lockwasher (4)
parts.
4. Capscrew (2)
18.
Nut (4)
14-4. Reassembly and installation
5. Screw (8)
19.
Nut
Refer to figure 14-1, and reassemble and install clutch control
6. Plate
20.
Lockwasher
components.
7. Clamp
21.
Lever
14-5. Adjustment
8. Boot
22.
Yoke pin assembly
Adjust clutch control linkage (refer to TM 5-3810-
9. Lockwasher (8)
23.
Capscrew
10. Nut (8)
24.
Rod
294-20).
11. Clutch pedal shaft
25.
Spring
12. Woodruff key
26.
Spring clip
13. Bushing (2)
Section II. REPAIR OF TRANSMISSION ASSEMBLY
14-6. Description
mission, a remote control assembly, a manual control
The carrier transmission has five forward speeds and
assembly, and a drop gear unit.
one reverse speed. However, with the drop gear unit,
14-7. Removal
two transmission speeds are available for each
Refer to paragraph 11-9 and remove transmission assembly
transmission shift lever position outside first gear The
14-8. Disassembly
total available speeds are, therefore, nine forward and
a. Refer to figure 14-2 and disassemble the remote
two reverse.
The complete carrier transmission
control assembly as follows:
assembly includes the main trans-
Figure 14-2. Remote control assembly, exploded view.
14-3
