TM 5-3810-295-34
diameter of the ring gear. Note the chamfer on the gear teeth so that the new gear may be installed in the same position.
b
Drive ring gear (5) from the flywheel with a suitable drift and hammer. Work around the periphery of the flywheel to
avoid binding the gear on the flywheel.
1. Screw
11. Screw
20. Screw
2. Retainer plate
12. Lock washer
21. Screw
3. Flywheel
13. Flat washer
22. Screw
4. Shim
14. Flat washer
23. Lock washer
5. Ring gear
15. Cover
24. Flywheel housing
6. Screw
16. Cover
25. Housing gasket
7. Lock washer
17. Cover gasket
26. Pipe plug
8. Access cover
18. Screw
27. Pipe plug
9. Cover gasket
19. Screw
28. Pipe plug
10. Screw
29. Oil seal
Figure 4-9. Flywheel assembly-exploded view.
c
Refer to paragraph 4-33 and remove the oil pan. Re move screws (6), lock washers (7), covers ) and gasket (9).
Remove screws (10) and (11), lock washers (12) and flat washers (13) and (14). Remove covers (15) and (16), and gasket
(17).
e
Remove screws (18), (19), (20), (21) and (22), and lock washers (23). Note the location of the various size screws
so they may be installed in their proper locations.
f
Thread two pilot stud into the cylinder block to guide the flywheel housing until the oil seal clears the end of the
crankshaft. Thread eye bolts into the pa on
4-9
