TM 5-3810-295-34
1
Retainer screw
13 Camshaft spacer
2
Lock washer
14 End plug
3
Gear nut retainer plate
15 Balance shaft
4
Nut
16 Camshaft
5
Oil slinger
17 Outer thrust washer
6
Screw
18 Idler gar
7
Screw
19 Bolt
8
Balance weight
20 Hub
9
Balance shat gear
21 Inner thrust washer
10
Camshaft
22 Idler gear bearing
11
Woodfuff key
23 End bearing
12
Thrust washer
24 Intermediate bearing
Figure 4-14. Camshaft and balance shaft assembly - exploded view.
c
from the gears. Remove weights (8).
Remove oil singers (5) from the front end of the
g. Place the camshaft and gear assembly in an
shafts.
d. Remove thrust washer retaining screws (6)
arbor press. Lay a wood block beneath the camshaft so
the threads will not be damaged when the shaft is
through a hole in the web of the gears.
e. Withdraw the shaft, thrust washer and gear as
pressed from the gear.
h. Place a short piece of -inch O.D. brass road be-
an assembly from the rear end of the cylinder block.
f. Remove balance weight retaining screws (7)
tween the end of the camshaft and the ram of the press.
4-15
