TM 5-3810-295-34
c. Repair the swig lock assembly by replacing
6-6. Cleaning, Inspection and Repair
any defective parts and adjust in accordance with
a. Clean the swing lock assembly with a wire
instructions contained in TM 5-3810-295-12.
brush or suitable cleaning solvent.
6-7.
Reassembly
b. Inspect screws, rod end and yoke end threads
Refer to figure 6-2 and reassemble the swing lock as
for damage or cross thread. Inspect pins and mating bores
shown.
for excessive wear, scoring or other damage.
Section III. REPAIR OF CRANE LOCK
6-8.
Description
6-10.
Cleaning, Inspection and Repair
The crane lock, once engaged, will prevent the crane
a. Clean all parts in an approved cleaning
from revolving on the carrier.
solvent such as Federal Specification P-D-680.
6-9.
Removal and Disassembly
b. Inspect all parts for cracks, excessive wear
Refer to figure 6-3, and remove and disassemble the
or other damage. Inspect lubrication fitting (11) for
crane lock assembly required for replacement of
obstructed part.
defective parts.
6-4
