TM 5-3810-295-34
(5) Carefully pull rotor (9) and vane assembly (10)
Figure 13-16.
half way out of ring (11) and install ring compressor
(6) Compress vanes (10, fig. 13-15) into rotor
arbor press and press shaft (21) off bearing.
(9) and remove from ring (11). Remove ring
(12) Remove washer (24), seal (25) and wiper (26)
compressor and remove vanes (10) from rotor
from body (27).
(9).
13-41.
Cleaning, Inspection and Repair
(7) Remove pin (12) from ring (11) and pin (13)
a. Clean all metal parts with cleaning solvent,
from plate (6).
Federal Specification P-D-680, or equivalent. Dry
(8) Remove shaft key (14). Carefully pull hub
thoroughly with compressed air.
adapter (15) from body (27).
b. Discard shaft seal (25, fig. 13-15), wiper (26), all
(9) Remove packing (16), ring (17) and packing
preformed packing, and back-up rings (17) and (3).
(18) and (19).
Replace discarded parts with new when reassembling.
(10) Remove lock ring (20) and with a soft
c. Check wearing surfaces of the cartridge
headed hammer lightly tap shaft (21) from body
pressure plates and ring for scoring and excessive
(27).
wear. Remove
(11) Remove snap ring (22) from shaft (21).
(12) Support the inner race of bearing (23) in an
13-31
