TM 5-3810-295-34
(4) Remove screws (6), lock washer (7) and lift
from bearing housing (11). Remove dust cover (12).
plate (8) off housing (11).
(6) Remove cotter pin (13) and nut (14) while
(5) Remove bearing race (9) and grease fitting
holding piston rod (30).
(10)
1 Nut
10 Grease fitting
19 Stop ring
28 Retainer
2 Nut
11 Bearing housing
20 Retaining ring
29 Seal
3 Screw
12 Dust cover
21 Washer
30 Piston rod
4 Lock washer
13 Cotter pin
22 Spring
31 Roll pin
5 Stop plate
14 Nut
23 Washer
32 Rod
6 Screw
15 Rod end
24 Retaining ring
33 Piston rod
7 Lock washer
16 Pipe plug
25 Retaining ring
34 Piston
8 Plate
17 Tube
26 Scraper
35 Pipe plug
9 Bearing race
18 Retaining ring
27 Wiper
36 Welded assembly
Figure 17-17. Self-centering steering cylinder exploded view.
(7) Unscrew rod end (15) from tube (17) and
and remove seal retainer (28) and seal (29) from welded
remove pipe plug (16).
assembly (36).
(8) Remove tubes (17) from welded assembly
(11) Remove roll pin (31) and slide piston
(36) and remove ring (18), stop ring (19), retaining ring
assembly off rod (32).
(20), washer (21), spring (22), washer (23) and retaining
(12) Remove piston rings (33) from piston (34).
ring (24).
(13) Remove pipe plug (35) from welded
(9) Remove retaining ring (25), scraper (26) and
assembly (36).
wiper (27) from piston rod (30).
b. Refer to figure 17-18 and remove and
10) Push piston rod (30) through welded assembly (36)
disassemble the tandem steering cylinder as follows:
17-24
