TM 5-3810-295-34
1 Cap screw
8 Pipe plug
2 Lock washer
9 Check valve
3 Pin
10 Valve cap
4 Handle
11 Spool
5 Screw
12 Valve body
6 Spool seal
13 Screw
7 Relief valve
14 Nameplate
Figure 17-15. Steering selector control valve--exploded view
with screws (13).
17-20. Cleaning, Inspection, Repair
(3) Push spool assembly (11) into body (12) and
a
Clean all metal parts with cleaning solvent
install spool cap (10).
(Fed. Spec. P-D-680, or equivalent) and dry thoroughly
(4) Install check valve (9) and pipe plug (8) in
with compressed air.
valve body (12).
b. Inspect all parts
r cracks, scoring,
(5) Install relief valve (7). Place spool seal (6) in
corrosion, or other defects.
position and install screws (5).
c. Replace all gasket, preformed packing and
(6) Attach handle (4) to spool assembly (11) and
other damaged or defected parts.
install pin (3) through spool seal (6) and handle (4).
17-21. Reassembly and Installation
b. Install selector control valve as follows:
a. Refer to figure 17-15 and reassemble
(1) Place valve in position in carrier cab and in-
selector control valve as follows:
stall lock washers (2) and screws (1).
(1) Coat all metal parts with clean engine oil to
(2) Connect hydraulic lines tagged for the
provide initial lubrication and ease of assembly.
selector control valve during removal.
(2) Install nameplate (14) on body (12) and
secure
17-22
