TM 5-3810-295-34
(1) Remove mounting hardware, cotter pin (1),
(14). Unscrew bearing assembly (15) and remove fit-
nut (2), bolt (3), cotter pin (4), nut (5) and bolt (6).
ting (16).
(2) Tag and disconnect all hydraulic line from
(6) Remove lock wire (17) and adjusting nut
the steering cylinder.
(18). Lift ball stud (19) from valve assembly. Remove
(3) Lift cylinder from vehicle.
nut (20) from ball stud (19).
(4) Remove nuts (7), lock washer (8) and bolts
(7) Unclip boot (21) and remove bolts (22).
(9). Remove rod and bearing assembly (11) and remove
Separate outer sleeve and vent (23), valve body (52) and
fitting (10).
welded assembly (59). Remove fitting (24) from outer
(5) Remove nut (12), lock washer (13) and bolt
sleeve (23).
1 Cotter pin
35 Centering spring
48 Spacer
2 Nut
36 Washer
49 Packing retainer
3 Bolt
37 Sleeve
50 Preformed packing
4 Cotter pin
38 Washer
51 Preformed packing
5 Nut
39 Bolt
52 Valve body
6 Bolt
40 Pipe plug
53 Snap ring
7 Nut
41 Preformed packing
54 Scraper
8 Lock washer
42 Pipe plug
55 Wiper
9 Bolt
43 Pipe plug
56 Seal retainer
10 Grease fitting
44 Check ball plug
57 Seal
11 Rod end and bearing assy.
45 Preformed packing
58 Piston and rod assembly
12 Nut
46 Check ball
59 Welded assembly
13 Lock washer
47 Preformed packing
14 Bolt
15 Bearing assembly
16 Grease fitting
17 Lockwire
18 Adjusting nut
19 Ball stud
20 Nut
21 Boot
22 Bolt
23 Outer sleeve and vent
24 Grease fitting
25 Ball seat
26 Ball seat
27 Washer
28 Spacer
29 Nut
30 Valve Spool
31 Seal
32 Packing retainer
33 Washer
34 Spacer
Figure 17-18. Tandem steering cylinder.
17-25
