TM 5-3810-295-34
(8) Remove ball seat (25) and (26), washer
preformed packing (47).
(27) and spacer (28) from sleeve (37).
(13) Remove spacer (48), packing retainer (49)
(9) Pull valve spool assembly out of valve body (52)
and preformed packing (50) and (51).
and remove nut (29).
(14) Remove snap ring (53), scraper (54), wiper
(10) Carefully slide valve spool (30), preformed
(55), seal retainer (56) and seal (57). Push piston and
packing (31), packing retainer (32), washer (33), spacer
rod assembly (58) out of welded assembly (59).
(34), spring (35), washer (36), sleeve (37), and washer
c. Refer to figure 17-19 and remove and
(38) off bolt (39).
disassemble the steering cylinders as follows:
(11) Unscrew pipe plug (40) and remove
(1) Tag and disconnect all hydraulic lines to the
preformed packing (41). Remove pipe pugs (42) and
cylinder.
(43).
(2) Remove cotter pin (1), nut (2), bolt (3),
(12) Pull check ball plug (44) and remove
cotter pin (4), nut (5) and bolt (6). Remove steering
preformed packing (45). Remove check ball (46) and
cylinder for disassembly.
1 Colter pin
7
Nut
13 Lock washer
19 Preformed packing
25 Seal
2 Nut
8
Lock washer
14 Bolt
20 Preformed packing
26 Welded assembly
3 Bolt
9
Bolt
15 Bearing assembly
21 Retaining ring
27 Nut
4 Cotter pin
10
Bearing assembly
16 Grease fitting
22 Scraper
28 Piston
5 Nut
11
Grease fitting
17 Bolt
23 Wiper
29 Piston rings
6 Bolt
12
Nut
18 End cap
24 Seal retainer
30 Piston rod
Figure 17-19. Steering cylinder - exploded view.
17-26
