TM 5-3810-295-34
Section IX. REPAIR OF PINTLE HOOK ASSEMBLY
19-31. General
19-32. Removal and Disassembly
The pintle hook is mounted on the rear of the carier
a. Refer to figure 19-13 and remove cotter pin (13) and
frame to be used for towing purposes.
nut (14) and remove pintle hook assembly (15) from the
carrier frame.
b. Refer to figure 19-13 and disassemble the
damage.
pintle hook assembly as follows:
c. Repair or replace aq defective parts.
(1) Remove lube fittings (1) from pivot pin (9)
19-34. Reassembly bnd Installation
and bolt (4).
a. Refer to figure 19-13 and reassemble the pintle hook
(2) Remove cotter pin (2), nut (3), and bolt (4)
assembly as follows:
and lift lock (12) off assembly.
(1) Assemble lock (12) by placing spring (10) in latch (11) and
(3) Remove screw (5) and chain (6). Remove
securing with pivot pin (9). Install cotter pin (8) in lock (12).
hook (7) from chain (6).
(2) Assemble hook (7) to chain (6) and install chain to carrier
(4) Remove cotter pin (8) and pivot pin (9) and
with screw (5).
lift latch (11) from lock (12). Remove spring (10)
(3) Place lock assembly (12) on hook (15) and install bolt (4),
from latch (11).
nut (3) and cotter pin (2).
19-33. Cleaning, Inspection and Repair
(4) Install tube fittings (1) in pivot pin (9) and bolt (4).
a. Clean all metal parts with cleaning solvent
(Fed. Spec. P-D-680 or equivalent) and dry
thoroughly.
b Inspect all parts for cracks, breaks or other
19-22 Change 1
