TM 5-3810-300-24 & P2
On the auxiliary drive gear and sliding clutch assembly
mark two adjacent teeth on the drive (larger width) gear
and mark the two teeth directly opposite.
Install the auxiliary drive gear and sliding clutch
assembly on the splines of the mainshaft, aligning both
sections with the splines. Mesh the marked tooth on
each countershaft between the marked teeth of the
auxiliary drive gear.
NOTE
KEEP THE MARKED TEETH ON THE COUNTERSHAFTS PARALLEL.
Place the intermediate shift yoke in the yoke slot of the
auxiliary drive gear/sliding clutch assembly, hub to the
rear.
4-192